phone envelop google-plus3
TICO bolt Isolation Washers

TICO MS/WA

Used in conjunction with TICO S/WA & TICO S/CO the MS/WA steel washer, is used to prevent transmission of vibration and machine noise through the bolt to the surrounding area.

Key Features:

  • Isolate bolts from a machine base
  • Outside diameter must be equal to that of the TICO S/WA washer
view MS/WA datasheet

Download Datasheets

Standard Stock Sizes

Part No. Inside
Diameter(mm)
Outside
Diameter(mm)
Thickness
(mm)
TL-000950 M10 30 3
TL-001000 M12 36 3
TL-001051 M14 42 3
TL-001078 M16 48 3
TL-001108 M18 54 3
TL-001159 M20 60 3
TL-001205 M24 72 3
TL-001256 M26 78 3

All standard size collars are supplied as packs of six.

Related Products

S/CO

S/WA

More Details

A bolt provides a direct transmission path for vibration from the machine to the floor, effectively short-circuiting the TICO pad. To prevent this, it is essential that the bolts are isolated from the machine base. This is achieved using TICO Washers.


Although the vast majority of machinery plant can be secured by TICO Pads and Adhesive, cases where bolts might be employed are where the centre of gravity falls outside the machine base as with an inclinable power press, radial drill, or where the centre of gravity is high.


In these applications, TICO MS/WA Washers should also be used to prevent transmission of machine noise and vibration through the bolt to the surrounding area. It is recommended that the nuts not be over tightened so as to firmly locate the machine without applying further compression to the TICO Pads.


TICO MS/WA steel washers - the outside diameter must be equal to that of the TICO S/WA washer.


  • There were some problems with your form submission:

Please check your inbox for Bolt Isolation Datasheet - Please note: Some email providers will block our correspondence, if this happens contact us using details provided on our website.