Treadmaster 2 Part Epoxy
- Suitable for use with other TICO products
- Full application details can be found on individual cans
- Suitable for use with other TICO products
- Full application details can be found on individual cans
Surfaces must be clean, dry and free from oil and grease. Existing paint, vanish, waxes, polishes, etc., must be removed. Fiber-glass, aluminum and steel surfaces should be lightly abraded with a nylon scouring pad and all dust removed.
Prepare the TICO and substraight before mixing the resin. Transfer the contents of container B into container A and mix thoroughly until the colour is consistent throughout the mix. Once mixed, the adhesive must be used without delay - under average environmental conditions a pot life of 20 minutes in the tin can be expected. Spreading the adhesive on to a flat plate after mixing will extend the useful pot life by helping to dissipate heat generated by the curing reaction. The adhesive should not be used when ambient temperatures are below 10°C or above 30°C. Immediately after use, clean tools, mixing vessels, brushes, etc. with methylated spirit.
Apply adhesive to the underside of the TICO. Position the TICO and apply pressure to consolidate the adhesive layers, ensuring that no air is trapped between the surfaces. Excess adhesive should be wiped off promptly with methylated spirit. Depending on environmental conditions the adhesive will begin to set in 2 - 4 hours and full strength will be achieved after 24 hours.
2 to 2.5m2 per tin, depending on surface.
Read the product label before use. Further details can be obtained from the Health and Safety Data Sheet.