phone envelop google-plus3 facebook2 twitter
Pipe Support/Clamp

Pipe Support / Pipe Clamp (Guide)

TICO Pipe Supports/Clamps have been specifically designed to minimise vibration transmission between pipework and hanger, and also preventing corrosion between dissimilar metals. Configuration enables the pipe to be gripped and supported while accommodating larger axial and torsional movements of the pipe.

Key Features:

  • Pipe is fully isolated from its support to prevent electrolytic corrosion
  • Prevents clamping damage to the pipes during installation
  • Also prevents wear due to fretting
  • Reduction in the transmission of noise and vibration
  • Maintenance free and long service life
  • Easy to install

Standard Stock Sizes:

For Stainless Steel Pipes

Pipe sizePart No.Size (mm)
mminchPipe O/D
12.701/2"JW 172-2121
19.003/4"JW 172-2727
25.401"JW 172-3434
31.751 1/4"JW 172-4343
38.101 1/2"JW 172-4949
50.802"JW 172-6161
76.203"JW 172-8989
101.604"JW 172-115115
152.406"JW 172-168168
203.208"JW 172-219219

For the stainless steel pipes O/Ds of pipes are based on BS 3974 Part 1 1974 Table 10.

For Cu/Ni pipes

Pipe sizePart No.Size (mm)
mminchPipe O/D
12.701/2"JW 173-1616
19.003/4"JW 173-2525
25.401"JW 173-3030
31.751 1/4"JW 173-3838
38.101 1/2"JW 173-4545
50.802"JW 173-5757
63.502 1/2"JW 173-7676
76.203"JW 173-8989
101.604"JW 173-108108
152.406"JW 173-159159
203.208"JW 173-219219

For Cu/Ni pipes (based on seamless 'Kunifer 10' sizes) O/D of pipes conform to BS 2871 Part 2 Table 3. BS MA Table 2 BS MA60. Also suitable for O/D stainless steel tubing.

Related Products

VHT Type

Grip Type

Clip Strips

More Details

The TICO Industrial Pipe Support family of products consists of Pipe Grips, Clip Strips, Clamp Blocks and Bondslips. TICO Pipe Support products perform a number of varied functions, which include:

1. Supporting and positively locating pipework over long spans.

2. Isolating the pipe from the mounting bolts and clamps to prevent fretting and corrosion.

3. Isolating dissimilar metals (e.g. between a pipe and a clamp) to prevent electrolytic corrosion.

4. Cater for movements in the pipe due to e.g. thermal expansion and contraction which might otherwise result in a build-up of stress in the pipe and potential rupture.

5. Maintaining pipe spacing of multiple pipe runs over long spans.

The JW reference number uniquely identifies each size of bolt. The suffix on the JW number is equal to the X dimension of the Pipe Grip (Pipe OD). There are two size ranges, based on different types of thin walled pipe:

JW 172 Series

Sizes based on stainless steel pipe outer diameters to BS3974 Part 1 1974

Rubber sleeve and pad colour coded Black

JW 173 Series

Sizes based on Cu-Ni pipe outer diameters to BS2871 Part 2

Rubber sleeve and pad colour coded Red

  • There were some problems with your form submission:

Please check your inbox for Guide Type Pipe Support Datasheet link - Note: Microsoft accounts may place our email into your Junk Folder.